針對這個問題，每種類型的機器不同、清洗物體及清洗劑的不同，那麽適宜的清洗溫度也就不同，但是隻有將超聲波清洗機的各項設置調到較佳，才能將機器的作用大化。通常情況而言，全自動超聲波清洗機設置什麽溫度的清洗效果好呢？

In view of this problem, different types of machines, different cleaning objects and cleaning agents will lead to different suitable cleaning temperatures. However, only when the settings of the ultrasonic cleaning machine are adjusted to a better level can the role of the machine be maximized. Generally speaking, what temperature is set for the full-automatic ultrasonic cleaning machine to achieve good cleaning effect?

91污都知道超聲波清洗機在進行清洗工作時，需要適宜的溫度去進行清洗。通常情況下，91污要求在清洗機水箱中的水達到40℃之後再放入清潔劑進行攪拌到完全融化，但除此之外還需要考慮室溫、清洗物品等條件，所以對超聲波清洗機的溫度控製一定不可以疏忽哦。

We all know that the ultrasonic cleaning machine needs a suitable temperature to clean when cleaning. Generally, we require that the water in the water tank of the cleaning machine reaches 40 ℃ and then add detergent to stir until it is completely melted. However, in addition, we also need to consider the room temperature, cleaning items and other conditions, so the temperature control of the ultrasonic cleaning machine must not be neglected.

超聲波清洗機一般在30℃-40℃時的清洗效果好，清洗液則溫度越高，效果作用越明顯。通常實際應用超聲波清洗機時，采用適宜的清洗溫度為40-60℃，尤其在天冷時若清洗液溫度低空化效應差，清洗效果也差。

The ultrasonic cleaning machine generally has good cleaning effect at 30 ℃ - 40 ℃. The higher the temperature of the cleaning liquid, the more obvious the effect. Generally, when the ultrasonic cleaning machine is actually used, the appropriate cleaning temperature is 40-60 ℃. Especially in cold weather, if the cleaning liquid temperature is low and the cavitation effect is poor, the cleaning effect is also poor.

因此有部分清洗機在清洗缸外邊繞上加熱電熱絲進行溫度控製，當溫度升高後空化效應易發生，所以清洗效果較好。當溫度繼續升高以後，空泡內氣體壓力增加，引起衝擊聲壓下降，反應出這兩因素的相乘作用。

Therefore, some cleaning machines wrap heating wires around the outside of the cleaning cylinder for temperature control. When the temperature rises, cavitation effect is easy to occur, so the cleaning effect is better. When the temperature continues to rise, the gas pressure in the cavity increases, causing the impact sound pressure to drop, reflecting the multiplication of these two factors.

假如你想在適宜的溫度下使用清洗機進行工作的話，可以先去把清洗機水箱裏麵的水更換了，要是成本過高的話，你可以保留多餘的熱水，等待冷卻和再利用，或者是在水箱裏走兩圈鋼管，管道中的水可以使溫度遠離水箱。要是你想要清洗機在70度或80度的溫度下進行工作，那就需要去追加熱板氣管和溫度控製。

If you want to use the washing machine to work at a suitable temperature, you can first replace the water in the water tank of the washing machine. If the cost is too high, you can keep the excess hot water, wait for cooling and reuse, or walk two circles of steel pipes in the water tank. The water in the pipe can keep the temperature away from the water tank. If you want the cleaning machine to work at a temperature of 70 or 80 degrees, you need to add a hot plate air pipe and temperature control.

通常來說，超聲波清洗機設備中的水清潔劑的適宜清洗的溫度為40~60℃之間，尤其是在那寒冷的天氣裏，洗滌液溫度過低的話產生的氣穴現象效果也不好，洗滌效果也不好。因此，一些清洗機設備會通過被圍繞在清洗滾筒外部的電熱絲加熱以控製溫度，在溫度升高時容易產生氣蝕，清洗的效果會更好。若溫度持續上升時，腔內的氣體壓力會增加，衝擊聲壓會降低，反映了這兩個因素的相乘效果。

Generally speaking, the suitable cleaning temperature of the water cleaner in the ultrasonic cleaner equipment is between 40 and 60 ℃. Especially in that cold weather, the cavitation phenomenon caused by the low temperature of the washing liquid is not good, and the washing effect is not good. Therefore, some cleaning machine equipment will be heated by the electric heating wire around the outside of the cleaning drum to control the temperature. When the temperature rises, cavitation is easy to occur, and the cleaning effect will be better. If the temperature continues to rise, the gas pressure in the cavity will increase and the impact sound pressure will decrease, reflecting the multiplication effect of these two factors.

實踐證明，在使用清洗機進行清洗的過程中，蒸氣壓、表麵張力、粘度及密度是有著明顯的影響因素，空化效應高。因此，超聲波清洗機的溫度一定要維持適宜的溫度範圍內，更多相關事項可以來91污網站www.ahfanglei.com谘詢。

It has been proved that the vapor pressure, surface tension, viscosity and density have obvious influence factors in the process of cleaning with the cleaning machine, and the cavitation effect is high. Therefore, the temperature of the ultrasonic cleaning machine must be maintained within the appropriate temperature range. For more information, please visit our website www.ahfanglei.com.