1. The operating temperature should not exceed 40.

2.設備周圍濕度75%，不能太幹。

2. The humidity around the equipment is 75% and should not be too dry.

3.保持清潔室的空氣流通。(如果沒有空氣流通，通風係統每小時2萬立方米以上)

3. Maintain air circulation in the clean room. (If there is no air circulation, the ventilation system should be at least 20000 cubic meters per hour)

4.碳氫化合物清洗機設備的排氣係統需要與室外連接。(排氣係統每小時2200立方米)

4. The exhaust system of the hydrocarbon cleaning machine equipment needs to be connected to the outdoor. (Exhaust system 2200 cubic meters per hour)

5.防爆照明燈應設置在設備布置範圍內5.防爆電器。

5. Explosion proof lighting should be set within the equipment layout range. 5. Explosion proof

electrical appliances.

6.設備嚴禁在陽光下爆炸，以免溫度升高，造成安全危險。

6. Explosion of equipment in sunlight is strictly prohibited to avoid temperature rise and safety hazards.

7.嚴禁在設備周圍5米內燃放煙花.引火作業及粉塵。

7. It is strictly prohibited to set off fireworks, ignite operations, and dust within 5 meters of the equipment.

8.用戶應直接離設備1(1)直接安裝電源(設備電源箱).空氣保護開關安裝在距離地麵1.6米以上的地方。(設備檢修時切斷電源方便使用)如果有專門的主電源櫃，現場必須距離設備5米。

8. Users should install the power supply (equipment power box) directly from the device 1 (1). The air protection switch should be installed at a distance of 1.6 meters or more from the ground. If there is a dedicated main power cabinet, it must be 5 meters away from the equipment on site.

9.冷水機組應設置在清洗設備旁邊3-5米之間，並安裝排氣管裝置。(排氣量為每小時2萬立方米)

9. The chiller should be installed between 3-5 meters next to the cleaning equipment and equipped with an exhaust pipe device. (Exhaust volume is 20000 cubic meters per hour)

使碳氫化合物清洗劑也能實現氣相清洗。使用鹵代烴清洗劑的工業清洗機利用鹵代烴清洗劑的低沸點，在清洗的一步加熱清洗劑，使其產生純淨的清洗劑蒸汽，並用溶液蒸汽清洗工件，使溶解在碳氫清洗設備的清洗液中的油汙不會留在工件表麵。由於碳氫化合物清洗劑的沸點高於閃點，因此在正常壓力下不可能清洗工件。真空清洗幹燥機利用真空狀態下液體沸點降低的原理，通過對密封的清洗罐進行真空大大降低了碳氫化合物溶劑的沸點，隻需將碳氫化合物清洗劑加熱到80℃左右，可使其沸騰，實現氣相清洗。

Enable hydrocarbon cleaning agents to also achieve gas-phase cleaning. The industrial cleaning machine using haloalkane cleaning agent uses the low boiling point of haloalkane cleaning agent to heat the cleaning agent in the first step of cleaning to generate pure detergent steam, and uses solution steam to clean the workpiece, so that the oil stains dissolved in the cleaning solution of hydrocarbon cleaning equipment will not remain on the workpiece surface. Due to the boiling point of hydrocarbon cleaning agents being higher than the flash point, it is impossible to clean the workpiece under normal pressure. The vacuum cleaning and drying machine utilizes the principle of reducing the boiling point of liquids under vacuum, greatly reducing the boiling point of hydrocarbon solvents by vacuuming the sealed cleaning tank. Simply heating the hydrocarbon cleaning agent to around 80 ℃ can make it boil and achieve gas-phase cleaning.

本文由碳氫清洗機提供幫助，更多的相關內容請點擊 http://www.ahfanglei.com希望本文能夠為您帶來幫助，感謝您的閱讀！

This article is provided by a hydrocarbon cleaning machine for assistance. For more related content, please click on http://www.ahfanglei.com I hope this article can be helpful to you. Thank you for reading!